Click For Crochet Abbreviations List

you will need: Melange yarns (100% wool; 50 g / 91 m) - 6 (7) 8 skeins serobezhevoy, 2 (2) 2 skein Charcoal, 1 (1) 1 skein sulfur, 1 (1) 1 skein brown; Knitting needles number 3.5 and 4; circular needles number 3.5 length 80 cm; 3 buttons with a diameter of 22 mm. 
# bolshoyrazmer # shikarnyezhenschiny 
# interesnyemodeli # interesnye_modeli 
Dimensions: S / M (M / L) L / XL Width of the product on the chest girth: approximately 87 (94) 100 cn Product length: 50 (51) 52 cm Density of knitting: 24 items x 32 p. = 10 x 10 cm, connected by pearl pattern on the needles No. 4. 


Important: if the instruction indicates only one number, then it applies to all sizes. 

2 points. Knit together the front one with a tilt to the left: 1 point. Remove, like the front one, knot the next loop of the front one and pull the removed loop through the knitted one. 

Important: when performing a subtraction after the gum, knit the front loop over the purl, 2 sec., Knit together the facial, when this is the first of 2 faces. loops and 2 n. knit together the front with a slope to the left, if this is the last of 2 persons. hinges (then the decreases will be almost imperceptible). 

Pearl pattern: 

1st row (= external row): 1 person.,

* 1 out., 1 person. *, Repeat from * to * to the end of the row. 

2nd row: knit loops on the picture. 

3rd row: 1 out., * 1 person., 1 out. *, Repeat from * to * to the end of the row. 

4th row: knit loops on the picture. 

Repeat these 4 rows. 

Back: on the needles No. 3.5, dial 130 (138) 146 p. With brown thread and knit with an elastic band: alternately 2 w., 2 persons. (1st row = izn. Row). After completing the brown thread 1 p., Change the thread to gray-beige and then knit with a thread of this color until the end of the gum. At a height of 4 cm knit gum finish purl near. Jump on the brown thread and the next ones. to knit a row with facial, uniformly turning off the hinges so that 105 (113) 121 p. is left on the knitting needles. To knit the next wear. a row of facial brown thread and then knit to the end of the detail with a gray-beige thread.

Go to the needles number 4, knit 1 persons. a row of facial gray beige thread and continue to work with a pearl pattern (see above). Through 63 p. from the beginning of the pearl pattern, make a mark in the middle and start forming the armholes. To do this, close the two, 2, 1, 1, 1 (3, 2.2, 1, 1, 1, 1) 3, 2, 2, 2, 1, 1, 1 lines at the beginning of each row on both sides. n. = on the spokes 85 (91) 97 n. When the height of the armholes from the mark is approximately 24 (25) 26 cm, close the neck averages of 27 n. and finish both sides separately. To round the neck, close the inner edge at the beginning of each row at 3, 2 p. At the same time, for the shoulder bevel, close at 8, 8, 8 (9, 9, 9) 10,10, 10 loops from the outer edge at the beginning of each row.

Right shelf: on the needles No. 3.5, type 75 (79) 83 p. With brown thread and knit with an elastic band in the same way as described for the back, finish the rows (= front edge of the shelf) with the front (= chrome. Loop). In all rows (1st row = external row), knit the edge loops with facial loops. Knit 1 p. brown thread, go to the gray-beige thread and then knit the thread of this color until the end of the gum. At a height of 4 cm knit gum finish purl near.

Jump on the brown thread and the next ones. to knit a row with facial, uniformly turning off the hinges so that 60 (64) 68 p. remain on the knitting needles. To knit the next wear. a number of facial and go to the needles number 4. Work to continue with gray, dark gray and gray-beige threads (when changing the color of the thread twist on the wrong side of the part). Knit the 1st p. face: the first 21 p. (chrome. + 20 p.) gray thread, the next 26 p. dark gray thread and the remaining 13 (17) 21 p. gray beige thread. Next, distribute the loops of the patterns as follows: a gray-beige thread knit with a pearl pattern, a dark gray thread - according to scheme 1, a gray thread - according to scheme 2 (= “braid”). Important: in 1st persons. row at the end of the row from the side of the seam with gray-beige thread 1 p. Continue to recruit 1 p. in each 4th p., looped loops should be included in the pearl pattern.

Through 63 p. from the beginning of the pearl pattern (16 p. on the edge), start forming the armhole: to do this, close 3, 2, 1, 1, 1 p. from the outer edge at the beginning of each row. Close the last loop to round the armhole, start to form a bevel V -shaped notch: to do this, close 2 points at the beginning of each row. Important: after 3 p. after the last loop closure for the armhole, continue dialing from the outside 1 p. in each 4th p., as when knitting to armhole. 

Having closed the V-shaped notch 17 (16) for the bevel 15 times for 2 points, continue to close for 1 point. When there are 31 (34) 37 points on the spoke, begin to form the shoulder bevel: close from the outer edge 8 (9) 10 3 p. times, at the same time continuing to close the hinges from the inner edge for the V-notch bevel - 7 more times.

Left shelf: knit, as the right shelf, but in a mirror image. 

Assembly: sew parts from the front side with a mattress and knit seam = mattress - longitudinal edges of the parts (= 1 p. X 1 p.), Knitted seam - edges with closed loops. Run shoulder seams (seam should not stretch).

Armhole slats: dial uniformly loops around the edge of the armhole on the spokes No. 3.5 with a brown thread from the front of the product (start and finish on sections with closed loops): 1 p. From each closed loop (if 1 p. Is closed at a time) , dial 1 additional loop between them), on straight sections of 1 p. from each row, skipping every 5-6th p. (the number of loops should be a multiple of 4 + 2 p.). Knit 1 out. row and go to the gray-beige thread. Knit 1 persons. a number of facial and continue to work with rubber = alternately 2 external., 2 persons. Important: in every persons. a number to perform a reduction: 1 person., 2 p. knit together the front with a tilt to the left, knit up to the last 3 p. on the needles, 2 p. knit together the front, 1 persons. Completing 11 p. gray beige thread, knit the last row of brown thread and thread the same color loop close. Run side seams,

Fastener plate: Knit on circular needles No. 3.5 
(in rows in the forward and reverse directions) with a brown thread. From the front side of the product, type evenly loops around the cutout edge (start and finish on sections with closed loops): 1 p. From each closed loop (if 1 p. Is closed at a time, dial 1 additional loop between them) and 42 n. along the edge of the neck of the back (the number of loops must be a multiple of 4). Knit 1 out. row facial and go for gray beige thread. Knit 1 persons. a number of facial and continue to work with rubber = alternately 2 external., 2 persons. (+ 1 chrome each. Loops at the beginning and end of the row, chrome loops in all rows knit facial!)

Note: after the 4th p. gray beige thread to make 3 holes for buttons: knit 6 p., 2 p. knit together the front with a tilt to the left, make a double nakid, 2 p. knit together the front, 'knit 8 p., 2 p. to the left, make a double wrap, 2 p. knit together the front *, repeat from * to * (just run 3 times). In the next w. A series of double knit strings and knit for the front and rear wall.

Completing 11 p. gray beige thread, knit the last row of brown thread and thread the same color loop close. Tying the beveled edges of the shelves: on the edge of each shelf, type on the spokes No. 4 with a brown thread from the front of the product evenly loops = 1 p. From every 2nd p. and 1 out. Tie up the row with facial ones, close the loop in the next row with the thread of the same color (the strapping must be level - do not stretch the edge, but do not pull together). To the plank of the left shelf acc. ground stitching buttons.